Trailer me platformë të ulët

Fliegl Tiefladeanhänger mit gerader Plattform

Custom Transport Solution
Configure your Fliegl trailer to your individual requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Attention: Archive pictures are used!

Chassis
Heavy-duty welded steel low-loader turntable trailer chassis
Heavy-duty turntable with ball-bearing race
Integrated storage box in turntable front section
Folding rear support
Wheel chocks with holders
Aluminium side underrun protection
Full-width rear mud flap
Semi-circular mudguards on 1st axle with anti-spray mud flaps
Anti-spray mud flaps behind 2nd axle
Spare wheel carrier incl. spare wheel (steel rim)
Ljdpfjzl R S Sjx Adcehi
Lockable plastic toolbox with shelf (padlock not included)
Lashing Equipment
3 pairs of integrated 10 t lashing points at the front
5 pairs of recessed 10 t lashing mushrooms on top and sides of the outer frame
Additional 5 t recessed lashing rings instead of stake pockets
Maximum spacing between lashing points: 1,200 mm
Drawbar
Height-adjustable drawbar with certified 40 mm towing eye, angled by 8°
Axles & Suspension
SAF drum brake axles
Laser-aligned axle and suspension geometry for reduced tyre wear and fuel consumption
Maintenance-free parabolic spring suspension with steel-rubber bushings
Wheels & Tyres
235/75 R17.5 tyres
Twin steel wheels, factory silver finish
Braking System
Dual-line air brake system
Spring parking brake
Two anti-mix coupling heads with air lines to towing vehicle
ABS & ALB with front ABS connector and connection cable
Compatible only with towing vehicles supporting ABS functionality
Electrical System
24 V lighting system
Multi-chamber rear lights
Yellow LED side marker lights
2 white front position lights
2 red/white rear outline marker lights
2 × 7-pin front connectors with connection cables
Loading Platform
Steel deck in front section
70 mm softwood flooring
Steel chequer plate over wheel arches
Rear beavertail with 70 mm timber flooring
Total low-bed loading area incl. beavertail: approx. 7,200 mm
Loading Ramps
2 steel loading ramps
Length: 2,800 mm
Width: 750 mm
Side-adjustable
Timber-covered
Spring-assisted lifting
Foldable lower ramp locks to prevent lateral movement
Operating Notes
A special permit is required for 10,000 kg axle load (approval must be obtained individually in each German federal state).
The stated gross vehicle weight is technically possible; depending on the cargo, the maximum permissible weight may not be achievable while complying with legal axle, kingpin and support loads.
Registration
Registration: Germany
EC type approval (2007/46/EC)
24/7 service hotline
Prepared for two-line licence plate holder
ECE R48 reflective contour marking (white sides, red rear)
ECE 70 rear warning plate