Engel e-victory 50/50 (2019) ecodrive

Engel e-victory 50/50

_ENGEL – Injection Moulding Machine Technical Data_

Serial number: 232665



Model: E‑VICTORY

_Plasticising Unit 1_

• Screw diameter: 18 mm

• Listed diameter options: 15 / 18 / 20 mm; 18 mm is installed

• Screw stroke: 80 mm

• Maximum injection volume: 20 cm³

• Screw speed: 450 rpm

• Screw torque: 75 Nm

• Plasticising rate, 3-zone screw: 4.2 g/s

_Injection Unit 1_

• Version: Standard

• Injection rate: 83.97 cm³/s

• Specific injection pressure, regenerative mode: 2,400 bar

_Nozzle 1_

• Nozzle stroke: 210 mm

• Nozzle contact force: 40.6 kN

_Material Cylinder 1_

• Screw L/D ratio: 24

• Heating zones, including nozzle: 4

• Heating power: 5.1 kW

• Note: maximum available equipment

_Clamping Unit_

• Clamping force: 500 kN (approximately 50 tonnes)

• Opening stroke + cylinder tolerance: 408 mm

• Maximum distance between platens: 600 mm

• Minimum mould height: 200 mm

• Platen dimensions, horizontal × vertical: 500 × 450 mm

• Drop-out chute width: 400 mm

• Maximum mould weight on moving platen: 300 kg

• Maximum mould weight on stationary platen: 300 kg

• Maximum total mould weight: 600 kg

• Dry-cycle stroke according to Euromap 6: 150 mm

• Dry-cycle time according to Euromap 6: 1.60 s

Mould weight notes:

1. Mould overhang according to mounting platens.
2. Less the weight of any rotary table.

_Ejector 1_

• Ejector stroke: 100 mm

• Ejector force: 39.8 kN

_Drive Unit_

• Oil reservoir capacity – injection unit, main tank: 135 l
Hsdpfez Iyldox Altofn

• Oil reservoir capacity – clamping unit, auxiliary tank: 0 l

_Machine Basics_

• Total weight without oil: 4.0 tonnes

• Total connected power: 65.0 kW

Transcription note: the small footnotes below the plasticising section specify
reference materials and test conditions. They are not fully legible in this
photo.